淺論可靠性試驗中結構件失效的分析應對

打開文本圖片集

摘  要：本文闡述了某卡車在可靠性試驗中擋泥板支架和保險杠失效問題的分析應對過程，描述通過CAE分析、結構材料工藝分析、實車驗證的過程，總結了可參考借鑒的分析應對方法。

關鍵詞：可靠性試驗; 結構件失效; 分析應對

中圖分類號：U466        文獻標識碼：A       文章編號：1005-2550（2022）02-0088-05

Analysis And Countermeasures Of Structural

Member Failure In Reliability Test

YU Qing-jie， WANG Hua-wu， LIU Zong-sheng， LANG Bao-yong

（ Dongfeng Commercial Vehicle Technical， Wuhan 430056， China）

Abstract： In this paper， the analysis and response process of fender support and bumper failure in reliability test of a truck has been described. According to the results of CAE analysis， structural material process analysis and real vehicle verification， the analysis  methods that can be used has been summarized.

Key Words： Reliability Test;  Structural Member Failure;  Analysis And Response

1    某卡車擋泥板支架失效分析

1.1   問題描述

某卡車在進行可靠性試驗中壞路試驗154Km時（輔助里程1009Km），左前輪后擋泥板支架斷裂，斷裂處為懸臂直管根部與鑄件支座的焊接處。（剩余4457字）