某汽油發動機機油消耗量高原因分析

打開文本圖片集

摘 要：針對某汽油發動機活塞機油消耗量高的問題，從發動機系統級、零部件級分析了該問題可能產生的原因并形成故障魚骨圖，以此為基礎利用仿真分析和試驗驗證相結合的方法對可能原因進行逐一排查。最后通過優化缸體筋板、活塞環結構、活塞回油結構等，有效解決了發動機活塞機油消耗量高的問題。

關鍵詞：機油消耗量 缸孔變形 回油結構

Abstract：Aiming at the problem of high oil consumption of a gasoline engine， the possible causes of the problem were analyzed from the engine system level and component level， and the fishbone diagram was formed. Base on this， the possible causes were checked one by one by the method od simulation analysis and test verification. Finally， by optimizing cylinder block， the second ring structure， piston oil return structure and so on， the problem of high oil consumption is effectively solved.

Key words：oil consumption， cylinder block deformation， piston oil return structure

機油消耗量為發動機工作過程中機油的消耗量，國家標準對發動機機油消耗量并沒有進行規定，GB/T 19055-2003《汽車發動機性能試驗方法》附錄A中A.3規定：在額定轉速全負荷工況機油與燃油的消耗比值不得超過0.3%，各主機廠開發發動機時，會對發動機的機燃比做更嚴格的規定，一般要求機燃比不大于0.15%。（剩余3320字）