平滑度儀容積檢驗方法研討

打開文本圖片集

摘要：本研究通過對平滑度儀相關標準中真空容器系統容積及其允許誤差、檢驗方法、檢驗條件的分析，利用測量不確定度評定方法，證實現有標準規定的檢驗方法和條件不滿足容積允許誤差要求，并對標準修訂提出了改進建議。

關鍵詞：平滑度儀;容積檢驗;不確定度

中圖分類號： TS736+.2  文獻標識碼： A DOI：10.11980/j. issn.0254-508X.2022.02.012

Discussion on the Volume Calibration Method of Smoothness Tester

YIN Baochun

（Sichuan Changjiang Papermaking Instrment Co.，Ltd.，Yibin，Sichuan Province，644000）

（E-mail：yinbaochun@sina. com）

Abstract：In this study，the volume and its permissible deviation，calibration method，and calibration conditions of the vacuum vessel sys?tem in the relevant standards of smoothness tester were analyzed and the method of measurement uncertainty evaluation was used to verify  that the calibration methods and conditions in the current standards were not compatible with the maximum permissible deviation of volume， and suggestions for revising the current standards were put forward as well.

Key words：smoothness tester; volume calibration;uncertainty

1 相關標準對平滑度儀真空容器容積及檢驗方法的規定

1.1 真空容器容積要求

GB/T 456—2002《紙和紙板平滑度的測定（別克法）》中 5.5.1規定：“大真空容器，包括到玻璃板表面的連接管，體積為（380±1）mL”;5.5.2規定：“小真空容器，包括到玻璃板表面的連接管，體積為（38±1）mL”。（剩余3632字）